Product was successfully added to your shopping cart.
  • HTU21D HUMIDITY SENSOR HTU21D HUMIDITY SENSOR
Previous

Digital Temperature Humidity Meter

Previous

Soil Moisture Hygrometer Sensor

HTU21D Humidity Sensor

Quick Overview

HTU21D Humidity Sensor

Availability: In stock

 Tk 605.00

Details

HTU21D Humidity Sensor. Description Things you should know about this sensor: Uses the I2C interface Typical humidity accuracy of ±2% Typical temperature accuracy of ±0.3C Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain). 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals Here’s the datasheet Only one HTU21D sensor can reside on the I2C bus at a time This sensor is ideal for environmental sensing and data logging. Perfect for a weather station or humidor control system. It is a very good replacement for digital humidity sensors such as the SHT15, SHT21, SHT25, HIH-4030, HIH6130 and capacitive humidity sensors such as the HH10D. Suggested Reading Things you might need to know: I2C Protocol Using the PCA9306 voltage translator Logic Levels Installing an Arduino library What are pull-up resistors? How to use a Connections: Breakout board to Arduino VCC → 3.3V GND → GND SDA → A4 SCL → A5 There are only four pins that need to be hooked up in order to start using this sensor in a project. One for VCC, one for GND, and two data lines for I2C communication. On an Arduino board connect the SDA pin on the breakout board to A4 and SCL to A5. If you have a newer Arduino, you can connect the SDA and SCL lines directly to the SDA and SCL lines broken out on the Arduino headers. This board runs at 3.3V. Be sure to power the board from the 3.3V pin! Because I2C is an open drain signal, there’s no need to worry about level shifting the signal; the 3.3V signal will be adequate to communicate with the Arduino and the signal will never reach a dangerous level for the pins on the HTU21D. Note: This breakout board has built in 4.7k pull up resistors for I2C communications. If you’re hooking up multiple I2C devices on the same bus, you may want to disable these resistors

Additional Information

Free Shipping No

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.